Filter
Top Products
20 www.ferrisindustries.com
Installation
Install Collector Mount Plate
(IS500Z Series, IS1500Z Series, IS2000Z Series, &
IS4500Z Series)
IMPORTANT NOTE: If the collector system is being
installed on an IS4500Z Series model, the Extreme
Duty Rear Bumper Kit (5600019) must be installed
first.
1. Install the collector mount plate (A, Figure 33) and
mount tabs (B) on to the bumper. Install two of
the 3/8-16 U-bolts (C) over the top bumper tube
and through the mount tabs and loosely secure
with the 3/8-16 nylock flange nuts (F).
NOTE: On IS500Z models use the inner mounting
holes when installing the collector mount plate and
mount tabs to the bumper with the 3/8-16 U-bolts
2. Install the remaining 3/8-16 U-bolt bolt (C) over
the middle bumper tube and loosely secure with
the 3/8-16 nylock flange nuts (E).
3. Center mount plate on the bumper and tighten all
the hardware securely.
4. Temporarily install the collector mount posts (A,
Figure 34) into the collector plate and install the
hitch pins (B). This will insure that the holes are
properly aligned for easy installation and removal.
5. Tighten the top nuts (C) securely and remove the
hitch pins and mount posts.
Figure 33. Install Collector Mount Plate
A. Mount Plate
B. Mount Tab
C. 3/8-16 U-Bolts
D. 3/8-16 Nylock Flange Nuts
B
A
Figure 34. Install Mount Posts & Hitch Pins
A. Mount Post
B. Hitch Pin
C. 3/8-16 Nylock Flange Nuts
A
C
D
B
D
B
D
C
Collector Installation