Filter
Top Products
19
PROBLEM PROBABLE CAUSE CORRECTIVE ACTION
Engine Will Not Start 1. Fuel tank empty. 1. Fill fuel tank with fresh fuel.
2. Starter insert not installed. 2. Install starter insert into control console.
3. Spark plug wire disconnected. 3. Place spark plug wire onto spark plug.
4. Wiring harness disconnected. 4. Connect wiring harness.
5. Battery dead. 5. Charge or replace battery.
Engine Stalls or Loses
Power After Running
1. Blade control is released or is not being held
securely against drive control.
1. Blade control should be held securely against
drive control at all times during operation.
2. Fuel tank empty. 2. Fill with fuel to proper level.
3. Engine pre-cleaner and/or air cleaner dirty. 3. Clean or replace precleaner and/or air cleaner.
4. Spark plug fouled or gap set improperly. 4. Service spark plug.
5. Water, debris or stale fuel in fuel system. 5. Drain and clean fuel system.
Excessive Vibration 1. Damaged, out of balance or bent mower blade. 1. Contact authorized dealer.
2. Loose blade components. 2. Contact authorized dealer.
3. Loose or missing air lift (if equipped). 3. Contact authorized dealer.
4. Lumpy or frayed belt. 4. Contact authorized dealer.
Mower Will Not Move/
Loss Of Traction
1. Build-up of debris on or around drive
components.
1. Clean debris.
2. Transmission cable adjustment required. 2. Adjust transmission cable.
3. Drive belt requires replacement. 3. Contact authorized dealer.
4. Damaged transmission. 4. Contact authorized dealer.
Cutting Grass Improperly1. Cutting height too low or high. 1. Adjust cutting height.
2. Forward speed too fast. 2. Adjust to a slower speed.
3. Cutting blade dull or damaged. 3. Contact authorized dealer.
Poor Grass Discharge 1. Forward speed too fast. 1. Adjust to a slower speed.
2. Grass is wet. 2. Mow when grass is dry.
3. Excessively worn or damaged blade. 3. Contact authorized dealer.
4. Build up of grass clippings and debris under
deck.
4. Clean deck.
5. Improper blade installed on deck. 5. Contact authorized dealer.
6. Blade installed improperly on deck. 6. Contact authorized dealer.
Oil Leaking 1. Loose dipstick. 1. Make sure dipstick/oil filler cap is securely in
place.
2. Loose drain plug. 2. Check and tighten drain plug.
3. Oil level is overfilled. 3. Drain excess oil.
4. Damaged oil seals. 4. Contact authorized dealer.
Troubleshooting
Not for
Reproduction