Filter
Top Products
9
SECTION 1 – ASSEMBLY INSTRUCTIONS
STEP 8
GRASS TUBE INSTALLATION
A. Attach Tube Handle and Handle Base to Tube
before installing Tube to catcher. Insert (2)
1/4-20 x 3/4” Carriage bolts through Handle
Base and holes in Tube as shown. See Figure
1.18. Place Tube Handle over bolts followed by
1/4” Internal Tooth lock washers and secure
with (2) 1/4-20 hex nuts. Tighten securely. See
Figure 1.18.
FIGURE 1.18
B. Place deck in lowest cutting height setting.
C. Slide upper end of Grass Tube (end without
Handle) into opening in Front Cover Assembly.
D. Slide lower end of Grass Tube over adapter
and rotate towards mower to secure Handle
Base under Latch. See Figure 1.19.
E. Adjust deck to desired cutting height.
FIGURE 1.19
HANDLE BASE
TUBE
HANDLE
ROTATE GRASS TUBE
TOWARDS MOWER