Filter
Top Products
8
SECTION 1 – ASSEMBLY INSTRUCTIONS
FIGURE 1.14
C. Hold the adapter in front of the deck. Align the
adapter lugs with the lug retainers in the hinge.
Push or lightly tap front of adapter towards the rear
until tight against deck. See Figure 1.15.
FIGURE 1.15A
FIGURE 1.15B
D. Install one of the previously removed bolts into
the hole in the center of the discharge opening and
through the hole in the adapter. Secure the adapter
to the deck with a flat washer and wing nut. See
Figure 1.16.
FIGURE 1.16
E. Attach tube latch to deck adapter. Insert one
1/4-20 x 3/4” Carriage bolt from inside through
lower hole in adapter. Place Tube Latch over bolt,
followed by 1/4” Internal Tooth lock washer and
secure with 1/4-20 hex nut. Align Tube Latch as
shown and tighten securely. See Figure 1.17.
FIGURE 1.17
HINGE NUT
SPRING
HINGE PIN
DEFLECTOR
REMOVED
LUG RETAINERS
ADAPTER
LUGS
ADAPTER
DEFLECTOR
FLAT WASHER &
WING NUT
TUBE
LATCH