Filter
Top Products
43
WARNING
To avoid serious injury, perform maintenance
on the tractor or mower only when the engine
is stopped and the parking brake engaged.
Always remove the ignition key, disconnect
the spark plug wire and fasten it away from
the plug before beginning the maintenance, to
prevent accidental starting of the engine.
Troubleshooting
Troubleshooting Chart
While normal care and regular maintenance will
extend the life of your equipment, prolonged or
constant use may eventually require that service be
performed to allow it to continue operating properly.
The troubleshooting guide below lists the most
common problems, their causes and remedies.
See the information on the following pages for
instructions on how to perform most of these minor
adjustments and service repairs yourself. If you
prefer, all of these procedures can be performed for
you by your local authorized dealer.
Troubleshooting the Rider
Problem Cause Remedy
Engine will not turnover or start.
Parking brake not engaged. Engage parking brake.
PTO (electric clutch) switch in ON
position.
Place in OFF position.
Out of fuel. If engine is hot, allow it to cool, then refill
the fuel tank.
Engine flooded. Move choke control to closed position.
Fuse blown. Replace fuse.
Battery terminals require cleaning. Clean the battery terminals.
Battery discharged or dead. Recharge or replace.
Wiring loose or broken. Visually check wiring & replace broken or
frayed wires. Tighten loose connections.
Solenoid or starter motor faulty. Repair or replace. See authorized dealer.
Safety interlock switch faulty. Replace as needed. See authorized
service dealer.
Spark plug(s) faulty, fouled or
incorrectly gapped.
Clean and gap or replace. See engine
manual.
Water in fuel. Drain fuel and replace with fresh fuel.
Gas is old or stale. Drain fuel and replace with fresh fuel.
Engine starts hard or runs poorly.
Fuel mixture too rich. Clean air filter. Check choke adjustment.
Spark plug(s) faulty, fouled or
incorrectly gapped.
Clean and gap or replace. See engine
manual.
Engine knocks.
Low oil level. Check/add oil as required.
Using wrong grade oil. See engine manual.
Excessive oil consumption.
Engine running too hot. Clean engine fins, blower screen and air
filter.
Using wrong weight oil. See engine manual.
Too much oil in crankcase. Drain excess oil.
Engine exhaust is black.
Dirty air filter. Replace air filter. See engine manual.
Engine choke control in CLOSED
position.
Open choke control.
Troubleshooting
Not for
Reproduction