Filter
Top Products
14
www.SnapperPro.com
Features and Controls
Choke
Close the choke for cold starting. Open the choke
once the engine starts. A warm engine may not
require choking. Pull the knob UP to close the choke.
Push to knob DOWN to open the choke.
Hour Meter
The hour meter measures the number of hours the
PTO has been engaged. The hour meter has a self
contained power source so the total hours are always
visible.
Ignition Switch
The ignition switch starts and stops the engine, it has
three positions:
OFF Stops the engine and shuts off the
electrical system.
RUN Allows the engine to run and
powers the electrical system.
START Cranks the engine for starting.
NOTE: Never leave the ignition switch in the RUN
position with the engine stopped–this drains the
battery.
Fuel Shut Off Valve
Turning the handle to the desired position determines
which tank will be supplying fuel. With the handle
pointing LEFT, it will draw fuel from the left-hand tank.
With the handle pointing RIGHT, it will draw fuel from
the right-hand fuel tank. With the handle pointing
towards the operator, it will shut off fuel flow to the
engine.
Models Equipped with Two Fuel Tanks:
Throttle Control
The throttle controls engine speed. Move the
throttle forward to increase engine speed and back
to decrease engine speed. Always operate at FULL
throttle.
PTO (Power Take Off) Switch
The PTO switch engages and disengages the mower.
Pull UP on the switch to engage, and push DOWN to
disengage.
Note: The further a lever is moved away from the
neutral position the faster the drive wheel will turn.
See the Operation section for proper steering
instructions.
Fuel Tank Cap
To remove the cap, turn counterclockwise.
Fuel Level Gauge
Displays the fuel level in the tank.
Parking Brake
DISENGAGE Releases the parking
brake.
ENGAGE Locks the parking brake.
Pull the parking brake lever back to engage the
parking brake. Move the lever fully forward to
disengage the parking brake. NOTE: To start the unit
the parking brake must be engaged.
Not for
Reproduction