Filter
Top Products
Removing & Re-attaching Grass
Catcher
14
REMOVING & RE-ATTACHING THE
GRASS CATCHER
Removing the Grass Catcher & tubes
1. Remove the hair pin clips (D, Figure 1) and hinge
pins (B) and remove the cover (A).
2. Remove the bags (A, Figure 2) by lifting them off their
hooks. Empty any grass out the bags.
3. Unclip middle and lower tube assembly (B, Figure 4)
and remove from turbo and upper tube.
4. Warning: Back plate (A) will fall when rod (D) is
removed. Remove the hair pin (B, Figure 3) and rod
(D) while holding back plate (A).
5. Lift the back plate and support assembly (A, Figure 3)
off hitch plate (C).
Figure 1. Remove the Cover
A. Cover C. Hinge
B. Hinge Pin D. Hair Pin Clip
A
B
C
D
Figure 2. Remove the Bags
A. Bags
WARNING
OPERATION WITHOUT TURBO & CATCHER
For operation without turbo, the mower deflector
MUST be properly installed in the down position
and retained by the spring latch (see turbo
operator’s manual).
A
B
A
D
C
Figure 3. Install Back Plate
A. Back Plate & Support C. Hitch Plate
B. Hair Pin D. Rod
Figure 4. Assemble Tubes
A. Upper Tube C. Clip
B. Middle & Lower Tube
To Turbo
Blower
A
C
B