Filter
Top Products
16
Regular Maintenance
AUGER GEAR CASE LUBRICATION
1. Place the snowthrower on a level surface.
2. Remove the pipe plug (A, Figure 9).
3. Check the lubricant level. It should be level with the
lower edge of the plug opening. If not, add The
Dealer Line Winter Weight Worm Gear Oil (available
from your dealer).
4. Re-install pipe plug, and tighten securely.
Figure 9. Auger Lubrication
A. Pipe Plug
Figure 8. Checking Tire Pressure
CHECKING TIRE PRESSURE
The air pressure in each tire (Figure 8) should be 20 psi
(136 kPa) and should be equal for both tires for best per-
formance. Be sure to keep caps on valves to prevent
entry of debris into the valve stem when tires are filled.
MAINTENANCE SCHEDULE
Check auger gear case lubrication.**
Lubricate snowthrower.
Check tire pressure.
Change engine oil.*
✛
Clean or replace spark plug.
✛
Check drive linkage/belt tension.
Lubricate Axle Shafts.
Check / Lubricate Free-Hand Linkage.
Lubricate Auger Shaft.***
25 Hours
10 Hours
Monthly
50 Hours
✛
Yearly
4-6 Hours
Yearly
10 Hours
10 Hours
Winter Weight
Worm Gear Oil
10W Oil and Grease
20 psi (1.37 bar)
See Engine Manual
See Engine Manual
N/A
Lithium Grease
10W Oil
Lithium Grease
MAINTENANCE REQUIRED FREQUENCY NOTES
* Change original oil after two hours of operation.
** Check oil level each fall and spring.
✛ See your engine Owner’s Manual.
***Lubricate each fall and spring.
Pipe Plug