Filter
Top Products
DEFLECTOR
The angle and distance of the discharged snow is con-
trolled by the position of the deflector. Engine speed also
affects distance of discharge.
The more the deflector is tilted back, the farther snow will
be thrown. Loosen the knob (figure 3) to tilt the deflector
back or forward, then retighten the knob.
SCRAPER BAR
&
SKID SHOES
On smooth surfaces such as concrete or asphalt, the
scraper bar should scrape the surface. On surfaces such
as gravel, the scraper bar should be high enough so that
it will not pick up gravel or debris.
The height of the scraper bar is controlled by raising or
lowering the skid shoes as shown in figure 4.
1. To raise the scraper bar height, rest the scraper bar
on a piece of wood, equal in thickness to the desired
height.’
2. Make sure the scraper bar is parallel to the ground
surface.
3. Loosen the skid shoe nuts and let the skid shoes
drop to the surface.
4. Tighten the nuts, making sure the skid shoes are
adjusted equally and are parallel to the surface.
5. To lower the height of the scraper bar, raise the skid
shoes.
6. If the scraper bar becomes worn, it can be replaced
by removing the hardware attaching it to the
snowthrower, installing a new one and then tighten-
ing the hardware.
Figure 3. Deflector Adjustment
Skidshoe
Figure 4. Skid Shoe Adjustment