Filter
Top Products
Regular- Maintenance
LUBRICATION CHECKING TIRE PRESSURE
A
CAUTION
It is very important that grease fittings on auger
shaft (figure 6) are lubricated regularly. If auger
rusts to shaft, damage to worm gear may occur if
shear pins do not break.
With an oil can, apply medium weight (IOW) oil to points
A
&
i3
shown in figure 7. There
are
two grease fittings in
the auger shaft (figure 6). Wipe fittings clean and apply
two or three shots of grease. Also, use grease on other
points shown.
Generally, all moving metal parts should be oiled where
contact is made with other parts. Keep oil and grease off
belts and pulleys.
The air pressure in each tire should be 20 psi (136
kPa)
and should be equal for both tires for best petiormance.
Be sure to keep caps on valves to prevent entry of mois-
ture.
I
Figure 8. Checking Tire Pressure
Transmission
8. Engine
C. Discharge chute
-\
E. Grease fittings
,t
3
Plug
D. Wheeis
&
axles
Auger gear case
Auger shaft
t
A. Use 1OW oil every 10 hours of use and at beginning of each season.
N-
8.
Add
5W-30
oil as required. Check engine every 5 hours of use and before each use.
w
C. Remove chute and coat unders$te of flange with clinging type grease annually.
w
D. Remove wheels and coat axles with clinging type grease annually.
N
E. Add grease to two grease fittings annually.
igure
7. Lubrication Points
9