Filter
Top Products
Specifications
ENGINE
Make
................................................................
Tecumseh
Cylinders.......................................................................
.1
Cycles.............................................................................
4
Crankshaft
....................................................... Horizontal
5HP
-
Model
No.
.....................................
See engine
I.D. plate
-Bore&Stroke..
........................Z-13/16
in.
x l-15/16
in.
(71.44 mm x 49.23 mm)
-
Displacement..
.......................................... .12.04 cu.
in.
(197.34 cc)
7HP
-
Model No. .....................................See engine I.D. plate
-
Bore
&
Stroke
............................2-314
in. x
2-17132
in.
(69.86 mm
x 64.31 mm)
-
Displacement..
.......................................... .15.04 cu.
in.
(246.5 cc)
Ignition
...............................................................
Magneto
Governor..
......................................................
Mechanical
Choke ...................................................................
Manual
Lubrication.. .............................................
Splash
system
Oil
Capacity ......................................
See engine manual
Fuel
Capacity..
.................................. See engine
manual
DRIVE
Type
__.___________._.______________
Gear drive transmission w/chain
and speed selection
Speeds.. ..........................
Three forward and one reverse
Axle..
.........................................................................
Solid
Tire Inflation
.........................................
.20
psi
(136
kPa)
AUGER HOUSING
Construction..
............................
Welded
steel
stampings
Effective Width
.....................................
22 in. (55.88 cm)
Auger Opening Height
with Extension.. .....................................
.16.5
in. (42 cm)
Spout Rotation
........................................................
1920
Scraper
Bar..
....................................
Wear
resistant steel
Skid Shoes..
......................
Adjustable,
heat-treated steel
AUGER
Construction..
........................... Ribbon
flite welded
steel
Bearings..
.....
Ultr
a high
Molecular Weight Polyethylene
IMPELLER
Construction..
............................................
4 steel blades
Bearings..
............ Pre-lubricated
and sealed ball bearing
Diameter.. ...............................................
.lO
in. (25.4 cm)
OVERALL DIMENSIONS
&
WEIGHT
Length ........................... ~.......................... 51
in. (132 cm)
Width
.....................................................
24
in. (60.96 cm)
Height .................................................
43-l/2 in. (110 cm)
Weight
-
5-55
.......................................................
,158
Ibs. (72 kg)
-
7-55
........................................................
178
Ibs. (80 kg)
SPECIFICATIONS ARE CORRECT AT TIME OF PRINTING
AND ARE SUBJECT TO CHANGE WITHOUT NOTICE.
15