Filter
Top Products
OPERATION
Operation Section 4-10
OPERATION
FM84A 09/03
© 2004 Alamo Group Inc.
4. STARTING THE TRACTOR
Before starting the tractor ensure the following:
¾ Conduct all pre-start operation inspection and service according to the tractor operator’s manual.
¾ All guards, shields, and other safety devices are securely in place.
¾ The parking brake is on.
¾ The PTO control lever is disengaged.
¾ The 3-point hitch control lever is in the lowered position.
¾ The hydraulic remote control levers are in the neutral position.
¾ The tractor transmission levers are in park or neutral.
Refer to the tractor owner’s manual for tractor starting procedures. Only start the tractor while seated and
belted in the tractor operator’s seat. Never bypass the ignition switch by short circuiting the starter.
After the tractor engine is running, avoid accidental contact with the tractor transmission to prevent sudden
and unexpected tractor movement.
The operator must have a complete understanding of the placement, function, and operational use of all tractor
controls before starting the tractor. Review the tractor operator’s manual and consult an authorized dealer for
tractor operation instructions if needed.
Essential Tractor Controls:
¾ Locate the light control lever
¾ Locate the engine shut off control
¾ Locate the brake pedals and the clutch
¾ Locate the PTO control
¾ Locate the 3 point hitch control lever
¾ Locate the hydraulic remote control lever
DANGER!
Start the Tractor only when properly seated in the Tractor seat. Starting
a Tractor in gear can result in injury or death. Read the Tractor
operator’s manual for proper starting instructions. (SG-13)
Use hand rails and steps when exiting the tractor. Be careful of your step and use extra caution when mud, ice,
snow or other matter has accumulated on the steps or hand rails. Use all handrails and steps for support and
never rush or jump off the tractor.
DANGER!
BEFORE leaving the Tractor seat, always engage the brake and/or set the
Tractor transmission in parking gear, disengage the PTO, stop the engine,
remove the key, and wait for all moving parts to stop. Place the Tractor shift
lever into a low range or parking gear to prevent the Tractor from rolling.
Never dismount a Tractor while it is moving or while the engine is running.
Operate the Tractor controls from the Tractor seat only. (SG-9)