Filter
Top Products
7
Putting the ASA 1 into operation
Putting the ASA 1 into operation
Preparing the ASA 1 for use
For table-top use, fix the device feet to the base of the ASA 1.
Do not fit the device feet when mounting the ASA 1 into a
19” rack.
̈ Ensure that the base of the ASA 1 is clean and free from
grease before fitting the device feet.
̈ Fix the device feet to the base of the ASA 1 by peeling off
the backing paper and fitting them as shown on the left.
̈ Place the ASA 1 on a flat, horizontal surface.
Fastening the stacking elements (see “Accessories and spare
parts” on page 17)
The stacking elements are designed to help protect the
operating elements from damage or deformation, e.g. if the
ASA 1 is dropped.
To fasten the stacking elements:
̈ Unscrew and remove the four recessed head screws (M4x8).
̈ Secure the stacking elements µ to the ASA 1.
CAUTION! Risk of staining of surfaces!
Some surfaces have been treated with varnish, polish or
synthetics which might cause stains when they come into
contact with other synthetics. Despite a thorough testing of the
synthetics used by us, we cannot rule out the possibility of
staining.
̈ Do not place the ASA 1 on delicate surfaces.
µ