Filter
Top Products
SUPPORT
POST
f
RETAINER
SPRING
REAR
MOUNTING
BRACKET
FIGURE 10
SUPPORT
BRACKET
PIN
SUPPORT
POST
ELBOW
I
5116 HEX
BOLTS
FORMED WAI
ELBOW I
SUPPORT
TUBE
END PLUG _" _ ELBOW SHIELD
_"_ LOCKNUTS
FIGURE 11
5. Assemble the support post to the rear mounting
bracket (Fig. 10) using support bracket pin and re-
tainer spring. Retainer spring shown furl size below.
Support post, latch pin and retainer spring furnish-
ed with bagger.
6. Mount elbow support tube to support post (Fig. 11)
using: two 5/16 hex bolts and two 5/16 Iocknuts
{shown full size below}. NOTE: Position elbow sup-
port tube as shown in Fig. 11, Tighten securely,
Elbow support tube and hardware furnished with
bagger.
©
7. Install end plug (Fig. 1!) on elbow support tube. End
plug furnished with bagger.
8. Mount the elbow retainer and the elbow shield to
the elbow support tube (Fig. 11) using: two form-
ed washers and two 5/16 Iocknuts {shown full size
below). NOTE: Do not tighten. Elbow retainer,
elbow shield and hardware furnished with bagger.
©
.
Slide elbow through elbow'retainer (Fig. t2 - Inset).
Secure elbow to elbow retainer using: two clips,
two screws, two washers and two acorn nuts.
NOTE: Mount clips in holes located 2 - I/2" from
edge of elbow. Hardware shown full size below,
Heads of screws and flat washers mount to the in-
side of elbow. Position clips with closed end of clip
facing tube opening as shown in Fig. 12 - Inset.
Tighten securely. NOTE: Tighten hardware
assembled in step 8. Elbow and hardware furnish-
ed with grass catcher.
10. Flip seat forward.
1111111111111111111]Q
-8-