Filter
Top Products
PARTSIDENTIFICATION
COVER
ELBOW
//€'
30 GALLON
CONTAINER
FIGURE 1
"CLUTCH/BRAKE"
POSITION
FIGURE 2
CHUTE
TUBE
ASSEMBLY
EXTENSION
CHUTE
ASSEMBLY
MOWER BLADE
CLUTCH LEVER
"DISENGAGED"
POSITION
KEY
BRAKE
"ENGAGED"
GEAR SHIFT
LEVER /"
®
CHUTE LATCH
PIN
To assemble your grass catcher you will need:
(1) 9/16" wrench (1} screwdriver
(2) 1/2" wrenches (t) 3/8" wrench
(2) 7/16" wrenches
(1} 7/8" wrench
NOTE: RIGHT HAND (R.H.) AND LEFT HAND (L.H.) ARE
DETERMINED FROM OPERATOR'S POSITION WHILE
SEATED ON THE TRACTOR.
ASSEMBLY-MOWER
READ THE "RULES FOR SAFE OPERA-
TION" CARFEULLY BEFORE OPERATING
YOUR GRASS CATCHER,
DO NOT OPERATE MOWER WITH GRASS
CATCHER ASSEMBLY PARTIALLY
INSTALLED.
All hardware for mower assembly found in bag labeled
"Mower Deck Hardware".
1. Turn
ignition key (Fig. 2) to "OFF" position.
i ill l i i i II'IH'I
REMOVE KEY TO PREVENT UNAUTHOR-
IZED USE,
MAKE ABSOLUTELY SURE THE BLADES
AND ALL MOVING PARTS HAVE COM-
PLETELY STOPPED.
2 , Push c/utch-brake peda/ complete/y into "BRAKE"
position (Fig. 2).
-4-