Filter
Top Products
16. Attach discharge guard to latch assembly and
mower housing (Fig. 8) using two 5/16 carriage
bolts and two 5/15 Iocknuts (shown furl size
below), Bolt heads to underside of mower housing.
Tighten securely, Hardware furnished with grass
catcher. NOTE: Tighten hardware assembled in
steps 13 and 15.
©
R.H.
RUNNER
17. Reattach mower to tractor. Refer to "Mower In-
stallation'" in your tractor owners manual.
ASSEMBLY-GRASS CATCHER
All hardware for grass catcher assembly is found in bag
labeled "Mounting Bracket Hardware".
1. Locate u-bolt in parts bag. Place two !/4 hex nuts
and two washers (shown full size below) on u-bolt.
NOTE: Back nuts down the full length of u-bolt. U-
bolt and hardware furnished with grass catcher.
2. Insert u-bolt through slot in drawbar by reaching
from underneath between drawbar and transaxle
(Fig. 9).
3. Place the rear mounting bracket (Fig. 9) on u-bolt
and secure with two washers and two I/4 Iocknuts
(shown full size below). Tighten finger tight, Rear
mounting bracket and hardware furnished with
grass catcher.
©
4. Secure the rear mounting bracket to the drawbar
(Fig. 9) using: one shoulder bolt, one washer and
one 3/8 Iocknut (shown full size below). Tighten
securely. NOTE: Tighten hardware assembled in
step 3. Hardware furnished with grass catcher.
WASHERS
1/4 LOCKNUTS
SHOULDER
BOLT
HEX NUTS
FIGURE 8
U-BO LT
DRAWBAR
WASHER • _
318 LOCKNUT
REAR
'tOUNTING
BRACKET
FIGURE 9
-7-