Filter
Top Products
i1,,,,i..... i i iiii,
,.SERVICE AND
TO REPLACE BELTS
The drive belts on this snow thrower are o! special
construction and should be replaced with original
equipmentbelts available from your nearest SEARS
Store or Service Center_
You will need the assistanceof a second person while
replacing the belts°
Drainthegasolinefromthefueltankbyremoving thefuel
line., Drain the gas and reinstall fuel line,,
AUGER DRIVE BELT
If yoursnow throwerwiltnotdischarge snow,and the
auger drive belt isdamaged, replace itas to!lows:
® Disconnect the sparkplugwire.
o Remove the beltcover(See Fig,,26).
® Loosenthebeltguides (SeeFig°27) and pullaway
from thedrivepulley.
e Loosentheauger idler pulley(See Fig. 28)andslip
the belt out.,
e Remove toptwo bolls that secureauger housing
to motor mount frame. Loosenbottom two bolts.,
Auger housingandmotormountIramewillseparate
hinged by bottom two bolts.
e Remove brake arm from housing, Do not remove
spdng,
e Removethebeltfromtheaugerdrive engine pulley
e Installthe original equipmentreplacement bell in
reverse order of removal,
e Reinstall brakearm intohousing,,Insure brake arm
isfullyinsertedinto housingand brake pad is riding
inpulley groove°
Position drive beltonto the auger drive putley,
Adjust thedr_vebelt(seeTo AdjustAuger Drive Belt
paragraph on page 18),,
Adjust the belt guides (see To Adjust The Belt
Guides paragraphon page 20)+
0
0
0
0
(Right Hand)
TRACTION DRIVE
IDLER PULLEY
_32
{Righ! Hand)
AUGER
PULLEY ENGAGED
O
FIG, 27
Reinstallthebeltcover.
Check clutch control cable adjustment (see page
18)+
,,i,, iii ,lirai,,,,11,
FIG.28
GUIDE
(Lalt Hand)
AUGER
DRIVE
BELT
:R DRIVE
PULLEY
PULLEY
!11' ll_j II I
BELT GUIDE
Hand)
3/32 INCH
IMPELLER
PUL L_Y
• Reconnect the spark plug wire,,
19