Sears 005734-0 Portable Generator User Manual


 
ELECTRICAL HAZARDS
All generators covered by this manual produce dangerous electrical
voltages and can cause fatal electrical shock. Utility power delivers
extremely high and dangerous voltages as does the generator when it
is in operation. Avoid contact with bare wires, terminals, connections,
etc., while the unit is running. Ensure all appropriate covers, guards
and barriers are in place before operating the generator. If work must
be done around an operating unit, stand on an insulated, dry surface
to reduce shock hazard.
Do not handle any kind of electrical device while standing in water, while
barefoot, or while hands or feet are wet. DANGEROUS ELECTRICAL
SHOCK MAY RESULT.
The National Electrical Code (NEC) requires the frame and external
electrically conductive parts of the generator to be connected to an
approved earth ground. Local electrical codes also may require proper
grounding of the generator electrical system.
In case of accident caused by electric shock, immediately shut down
the source of electrical power. If this is not possible, attempt to free the
victim from the live conductor. AVOID DIRECT CONTACT WITH THE
VICTIM. Use a non-conducting implement, such as a rope or board,
to free the victim from the live conductor. If the victim is unconscious,
apply first aid and get immediate medical help.
Never wear jewelry when working on this equipment. Jewelry can
conduct electricity resulting in electric shock, or may get caught in
moving components causing injury.
FIRE HAZARDS
For fire safety, the generator must be operated and maintained properly.
Operation must always comply with applicable codes, standards, laws
and regulations. Adhere strictly to local, state and national electrical
and building codes. Comply with regulations the Occupational Safety
and Health Administration (OSHA) has established. Also, ensure that
the generator is operated in accordance with the manufacturer’s
instructions and recommendations. Do not alter the construction of the
generator or change controls which might create an unsafe operating
condition.
Keep a fire extinguisher near the generator at all times. Extinguishers
rated “ABC” by the National Fire Protection Association are appropriate
for use on the standby electric system. Keep the extinguisher properly
charged and be familiar with its use. If there are any questions
pertaining to fire extinguishers, consult the local fire department.
Avoid spilling gasoline on a hot engine. NEVER add fuel while the unit is
running. Allow unit/engine to cool entirely before adding fuel. DO NOT
overfill the fuel tank. Always allow room for fuel expansion. NEVER fill
fuel tank indoors.
EXPLOSION HAZARDS
Do not smoke around the generator. Wipe up any fuel or oil spills
immediately. Ensure that no combustible materials are left on or
near the generator, as FIRE or EXPLOSION may result. Keep the area
surrounding the generator clean and free from debris.
Gasoline is extremely EXPLOSIVE.
STANDARDS INDEX
In the absence of pertinent standards, codes, regulations and laws,
the published information listed below may be used as a guideline for
operation of this equipment. Always reference the latest revision available
for the standards listed.
1. NFPA No. 70, NFPA HANDBOOK OF NATIONAL ELECTRIC CODE.
2. Article X, NATIONAL BUILDING CODE, available from the American
Insurance Association, 85 John Street, New York, N.Y. 10038.
3. AGRICULTURAL WIRING HANDBOOK, available from the Food and
Energy Council, 909 University Avenue, Columbia, MO 65201.
4. ASAE EP-3634, INSTALLATION AND MAINTENANCE OF FARM
STANDBY ELECTRICAL SYSTEMS, available from the American
Society of Agricultural Engineers, 2950 Niles Road, St. Joseph, MI
49085.
5. NFPA No. 30, FLAMMABLE AND COMBUSTIBLE LIQUIDS CODE.
3
IMPORTANT SAFETY INSTRUCTIONS