Filter
Top Products
Service Electrical - Page 57
SERVICE ELECTRICAL
1. Remove battery from mower. (See Removing and
Installing Battery in this section.)
2. Connect positive (+) charger cable to positive (+)
battery terminal.
3. Connect negative (–) charger cable to negative (–)
battery terminal.
4. Plug in charger cord.
5. Charge battery using a 12 Volt battery charger at a
rate of 6–10 amperes for a minimum of 1 hour and no
more than 2 hours.
6. Unplug charger cord. Remove charger cables.
7. Install battery. (See Removing and Installing Battery
in this section.)
cCAUTION: Avoid injury. DO NOT attempt to
open, add fluid or service battery. Any attempt
to do so will void warranty and lead to
possible injury.
Battery gas is explosive:
- DO NOT smoke while you charge battery.
- Keep all flames and sparks away.
- DO NOT charge frozen battery.
- DO NOT connect booster battery negative (-)
cable to starting vehicle negative (-) terminal.