Filter
Top Products
Service Engine - Page 42
SERVICE ENGINE
7. Oil must be between ADD and FULL marks.
8. Add oil to FULL mark if necessary. DO NOT overfill.
9. Install and tighten dipstick. Lower hood.
Changing Engine Oil
1. Run engine to warm oil.
2. Park tractor on level surface. STOP engine, LOCK
park brake and remove key.
3. Wipe debris and dirt from around dipstick.
Picture Note: Model S2048 used for photo purposes.
4. Put drain pan under drain extension (A).
5. Remove drain plug (A) and drain oil into oil drain pan.
6. Replace drain plug. Tighten to: 13.6 N•m (10 ft. lb.).
7. Remove dipstick (B) and refill with new oil of
recommended grade.
• Approximate engine oil capacity: 2.1 L (2 qt)
cCAUTION: Avoid injury. Hot Engine and Hot
Oil can cause severe burns. Allow engine
temperature to drop from hot to warm level
before attempting to change oil.
M97157
B
A