Filter
Top Products
Operating Mower - Page 29
OPERATING MOWER
Adjusting Mower Gage Wheels
1. Check tractor tire pressure. Inflate tires to the correct
pressure. (See Checking Tire Pressure in Service -
Miscellaneous section.)
2. Raise mower lift lever to TRANSPORT (upper)
position and adjust cutting height. (See Adjusting
Cutting Height in this section.)
3. Remove bolt (A), bushing (B), washer (C), and tighten
with nut (D).
NOTE: Bottom of gage wheels should be
approximately 6-13 mm (1/4-1/2 in) from the ground
when properly adjusted.
4. Move mower gage wheels, one on each side, to one
of four holes for desired position.
5. Install bolt and tighten with nut.
6. Move lift lever forward to MOWING (lower) position.
7. Check distance from gage wheel to ground.
8. Adjust gage wheels if necessary.
cCAUTION: Avoid injury. Before you adjust
gage wheels:
• STOP engine
• Remove key.
• Wait for blades to STOP
IMPORTANT: Avoid machine damage. Mower
gage wheels must not ride on ground to support
mower weight. Adjust gage wheels each time you
change cutting height.
M88571
D
A
B
C