Filter
Top Products
Section 7
27
MAINTENANCE CHART - RECOMMENDED SERVICE INTERVALS (CONT'D)
HOURS
Break-In 8 40 100 200 500 Procedure Comments
(First 10)
X Apply grease to fittings See paragraph 7.2
X Check hardware for tightness
X Change engine oil filter See paragraph 7.4
X Check hydraulic oil level See paragraph 7.3
X Replace engine fuel filter See paragraph 7.5
X Drain hydraulic system and See paragraph 7.3
replace hydraulic oil Use SAE 20W50
Motor Oil
X Replace hydraulic oil filter See paragraph 7.3
X Replace power unit gearbox See paragraph 7.13
lubricant
X Replace lubricant in cutter deck See paragraph 7.12
gear boxes
X *Check Clutch Air Gap See your local Scag
Dealer
* Perform these maintenance procedures more frequently under heavy load, extreme dusty or dirty
conditions.
7.2 LUBRICATION
GREASE FITTING LUBRICATION CHART
(SEE FIGURE 7-1)
LUBRICATION NO. OF
LOCATION INTERVAL LUBRICANT PLACES
1 Brake Linkage 100 Hours/Bi-Weekly Chassis Grease 2
2 Caster Wheel Pivot 100 Hours/Bi-Weekly Chassis Grease 2
3 Caster Wheel Bearings 100 Hours/Bi-Weekly Chassis Grease 2
4 Cutter Deck Pivots 100 Hours/Bi-Weekly Chassis Grease 2
5 Brake Lever 100 Hours/Bi-Weekly Chassis Grease 1
6 Rear Wheel Bearings 100 Hours/Bi-Weekly Chassis Grease 1
7 Cutter Deck Drive Shaft 100 Hours/Bi-Weekly Chassis Grease 3
8 Steering Control Levers and Linkage 100 Hours/Bi-Weekly Chassis Grease 4
9 Cutter Deck Spindles 40 Hours/Weekly +Lithium MP White Grease 2125 3
10 Blower Bearing 8 Hours/Daily +Lithium MP White Grease 2125 1