Filter
Top Products
13
Section 4
Figure 4-7 Improper Operation on a Slope
4. Fill the fuel tank with fresh, clean fuel at the end of
every day of operation.
5. Check the tire pressure. Inflate tires if necessary.
4.10 HOPPER, MULCH or SIDE DISCHARGE
OPERATION
When mowing with the cutting deck setup for rear discharge
into the hopper, the blower belt must be installed. A control
lever located on the left side of the tractor (Figure 4-8) will
release tension on the idler pulley to allow the belt to be
installed (grass catching operation) or removed (mulching
or side discharge operations). The cutter deck must also
be adapted to the type of cutting that the operator is
attempting to perform.
4.8 PARKING THE MOWER
1. Place the speed control in the neutral position.
2. Slow the engine to idle speed.
3. Engage the parking brake.
4. Turn the ignition key to the OFF position and remove
the key.
4.9 AFTER OPERATION
1. Wash the entire mower after each use. Do not use
high pressure spray or direct the spray onto electrical
components.
-IMPORTANT-
Do not wash a hot or running engine. Cold
water will damage the engine. Use compressed
air to clean the engine if it is hot.
2. Keep the entire mower clean to inhibit serious heat
damage to the engine or hydraulic oil circuit.
3. Check the drive belts for proper alignment, correct if
necessary. Remove any debris build up.
Figure 4-8 Blower Belt Release
Figure 4-9 Baffles for Rear Discharge
SCR 2K IOS
Blower Belt
Blower Belt
Release Pedal
SCR 2K BBR
SCR 2K RD
Rear Discharge
Baffle
Side Discharge
Shutoff Baffle