Filter
Top Products
4
6. Install the blower mounting bracket to the deck
using 1/2-13 x 1-1/2" hex head bolts (p/n 04001-
71), 1/2" spring lockwashers (p/n 04030-06), and
1/2-13 elastic stop nuts (p/n 04021-07). See
Figure 3-3, Page 3. Do not fully tighten the
hardware at this time.
7. Block the right front side on the cutter deck and
remove the hang chain. Install the deck lift link.
Secure using hex head bolts (p/n 04001-32,
04001-20), flatwashers (p/n 04041-07), spacers
(p/n 43212), and serrated flange nuts (p/n 04019-
04). See Figure 3-3.
8. Install the new belt cover from the cutter deck to
the blower mounting bracket and secure with
one of the original belt cover plastic wing nuts.
9. Install the catch plate (p/n 423297) to the blower
assembly using 3/8-16 x 1-1/4" carriage bolts
(p/n 04003-11) facing upward. Secure with 3/8"
spring lockwashers (p/n 04030-04) and 3/8-16
elastic stop nuts (p/n 04021-09). Do not fully
tighten the hardware at this time.
10. Install the blower assembly to the mounting
bracket and secure with the mounting pin. See
Figure 3-4, Page 3.
11. Align the blower assembly with the discharge
opening of the cutter deck. Tighten the
hardware for the mounting bracket. Then
tighten the hardware for the catch plate.
12. Install the belt to the spindle pulley. When
replacing the belt, see figure below.
14. Install the hopper mounting brackets (p/n 451512)
to the outside of the frame on the rear of the
machine using 3/8-16 x 1" hex head bolts
(p/n 04001-19) and 3/8-16 elastic stop nuts (p/n
04021-09). See Figure 5-6, Page 13.
15. Install the hopper hood assembly onto the catcher
frame assembly and secure with 3/8-16 x 2-1/4"
hex head bolts (p/n 04001-46) and 3/8-16 elastic
stop nuts (p/n 04021-09) in the mounting holes.
See Figure 5-6, Page 13.
16. Install the catcher support bracket onto the rear of
the machine and secure with 5/16-18 x 1" carriage
bolts (p/n 04003-04) and 5/16-18 serrated flange
nuts (p/n 04019-03) See Figure 3-5.
FRONT SIDE
IDLER PULLEY
BACK SIDE
IDLER PULLEY
BLOWER
PULLEY
SPINDLE
PULLEY
Catcher Support Bracket
FIGURE 3-5
13. Install the plastic belt cover and secure with the
plastic wing nuts. See Page 18 of the Illustrated
Parts List for proper installation.
17. Install the heat shield to the hopper hood
assembly and catcher frame assembly. Secure
using the hardware specified in Figure 5-6, Page
13.
18. Install adapter (p/n 461419) to the blower
assembly and secure with the strap.