Filter
Top Products
ASSEMBLY INSTRUCTIONS
9
Fig. 6
Fig. 5
Fig. 7
INSTALLING THE HANDLEBAR
1. Place the handlebar between the bottom and middle
clamp pieces (Fig. 4).
2. While holding the three pieces together, position the
handlebar underneath the shaft tube and align with
the top clamp.
NOTE: The holes in the clamp assembly will line up only
when assembled correctly.
3. One at a time, hold a hex nut in the bottom clamp
recess with a finger and install a screw through the
clamp assembly. Start screw with a large Phillips
screwdriver. do the same with the other three (3)
nuts and screws. Do not tighten until you make the
handle adjustment.
4. Position the two (2) handlebar clamps with one on
each side near the top.of the handlebar. Swing the
handlebar up until it sets to the outside of the two
mounting brackets on the engine (Fig.5).
NOTE: Positioning the handlebar onto the mounting
brackets may require slightly spreading the
handlebar.
5. Slide the two (2) handlebar clamps down over the
mounting brackets (Fig. 6).
NOTE: It may be required to loosen or remove the
thumb screws on the handlebar clamps to
spread them to fit over the mounting brackets.
6. Center the handlebar and tighten the two (2)
mounting bracket clamps and the four (4) handlebar
clamp screws evenly until the handlebar is secure.
(Figs. 6 and 7).
Fig. 4
Bottom
Clamp
Nut
Middle
Clamp
Thumb
Screw
Clamp
Mounting
Bracket
Mounting
Bracket
Spacer
Nut
Handlebar
Screw
Top
Clamp
Handlebar Clamp
Handlebar
Handlebar