Filter
Top Products
ASSEMBLY INSTRUCTIONS
10
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Throttle Wire Hole
Throttle
Wire Slot
Fig. 8
THROTTLE CABLE ASSEMBLY
1. Wrap the throttle wire once around the handlebar
(Fig. 8).
2. Depress the throttle trigger and locate hole for the
throttle wire (Fig. 9).
3. With the throttle trigger depressed, place the barrel
end of the throttle wire inside the hole of the trigger
(Fig. 10).
4. Release the throttle trigger and guide the cable up
into the slot of the trigger housing.
5. Push the throttle cable housing into the trigger
housing until it snaps into place (Fig. 11).
6. Route the throttle cable through the clip on the right
handlebar mounting bracket (Fig. 12).
NOTE: Ensure the throttle cable is fitting into the guide
at the carburetor plate on the engine. If it does
not, the throttle will not work properly (Fig. 8).
Throttle Cable
Carburetor
Plate Guide
Mounting
Bracket
Throttle
Cable
Engine