Filter
Top Products
10
5. SQUEEZE THE THROTTLE TRIGGER TO FULL
THROTTLE. Hold the trigger in this position.
6. PULL THE STARTER ROPE BRISKLY until you hear
the engine sounds like it wants to run (normally 2 to 5
pulls).
7. PLACE THE CHOKE LEVER IN THE "PARTIAL"
POSITION. Pull the starter rope briskly 1 to 3 times to
start the engine. See Fig. 15.
NOTE: If the engine does not start immediately,
repeat steps 2 through 7.
8. After the engine warms up for 5 to 10 seconds,
PLACE THE CHOKE LEVER IN THE "RUN" POSI-
TION. See Fig. 15.
STOPPING
To stop the engine, push and hold the stop button until the
engine comes to a complete stop (Fig. 18).
NOTE: To prevent vapor lock, avoid setting the
unit in the sun.
Fig. 17
STARTING/STOPPING INSTRUCTIONS
Fig. 16
STARTING
1. MIX OIL WITH GAS per instructions (page 8).
2. FULLY PRESS AND RELEASE THE PRIMER BULB
UNTIL FUEL IS VISIBLE IN BULB. See Fig. 14 for
the primer bulb location.
4. HOLD THE BLOWER/VAC IN THE STARTING
POSITION (Fig. 16 for blower, Fig. 17 for vacuum).
3. PLACE THE CHOKE LEVER IN THE FULL "CHOKE"
POSITION. See Fig. 15.
Primer
Bulb
Fig. 14
Fig. 15
Fig. 18