Filter
Top Products
tep Part to remove
Description
Remarks
Tool
6. Rotor
(3) Use a bolt and oil as a tool for pulling
out rotor in the following procedures :
1. Pour engine oil into the center hole of
rotor shaft.
Fill with oil to the shaft end.
(See Fig. 10-19.)
2. Prepare a bolt with the following
thread size:
RGX1800,2400,3500. . MlOXP1.25
RGX5500........... M12XP1.50
3. Apply a few turns of seal tape around
the tip of the bolt.
(See Fig. 10-20.)
I
I
!
I
Fig. 10-19
Fig. 10-20
until the rotor comes off loose.
lit pressure inside the rotor
apart the rotor from the
Socket wrench
Fig. 10-21