Filter
Top Products
itep Part to remove
Description Remarks Tool
4.
Rear Cover
(1) Remove the end cover. (See Fig. 10-l 1.)
10 mm spanner 01
66
bolt . . . . . _ . . . . . _ _ . . _
4
pcs.
box wrench
(2) Take off the rear cover.
1. Remove the four bolts which fasten
10 mm spanner 01
the rear cover to the front cover.
box wrench
6@f,c,lt . . . . . . . . . . . .._.. dpcs.
I
2. Use a special tool “REAR COVER
PULLER” to remove the rear cover.
a) Insert the two screws of the special
Insert the two screws
tool into the thread holes of the
sufficiently and evenly,
rear cover.
or the thread hole may be
b) Apply the center bolt of the special
damaged at removing.
tool on the head of the through bolt.
c) Tighten the center bolt to pull out
the rear cover.
Fig. lo-11 Fig. lo-12
In the case that REAR COVER PULLER” is unavailable, remove the
rear cover by the following instructions.
2’. Hit on the boss and legs -of rear Do not give a strong hit
cover with a plastic hammer to on the boss or legs.
loosen.
Box wrench
Plastic hammer
Fig. lo-13
- 56 -