Filter
Top Products
Step Part to remove
Description : Remarks
Tool
5.
Staitor (1) Remove the four bolts which fasten the
10 mm socket
stator to the rear cover.
wrench
(See Fig. 10-14.)
&BOLT . . . . . .4pcs.
60 SPRING WASHER
Fig. 10-14
(2) Rut a piece of lumber on the floor in
upright position.
(See Fig. 10-E)
(3) Hold the rearcover and stator upside
down with both hands.
(4) Down the rear cover and stator over the
lumber lightly hitting the bottom of rear
cover to the top end of lumber to pull out
the stator.
(See Fig. 10-16.)
+NOTES]
1. Apply fingers to stator coil to keep the stator from dropping on the floor.
2. Gently hit the bottom of rear cover to the top end of lumber several times until the stator
comes out loose.
Fig. 10-15
Fig. 10-16
- 57 -