Filter
Top Products
12.
CHECKS
and
CORRECTIONS
After dismantling and cleaning the engine parts, check them, and if necessary, correct them, according to the correction
table.
The correction table applies whenever the engines are repaired. Its contents should be thoroughly understood by those
who undertake the repairing. Its specifications must be abided by to effect correct maintenance.
Below, terms employed in the correction table are explained.
CORRECTION
All operations performed
on the engine parts for the purpose
of
improving or recovering the engine performance,
consisting of repair, readjustment, and replacement.
STANDARD
SIZE
Design dimension of the part without the tolerance.
CORRECTION TOLERANCE
Tolerance
on
the re-finished part dimension or on the readjustment dimension.
CORRECTION LIMIT
Limit on the part and adjustment, beyond which any dimensional and functional change, due to wear, burn and
other causes will adversely affect the normal engine performance.
USE
LIMIT
Limit, beyond which the part
is
no longer usable, due to defects
m
function or strength.
All dimensions in the CORRECTION
TABLE
are give
in
millimeter, except where otherwise specified.
-29
-