Filter
Top Products
-- 4 --
Small
Opening
Zipper
Opening
Elbow
Tube
Rib
NOTE: Make sureedgeof thesmallopening
is flush against the flared area of the elbow
tube, and the r ib on the elbow tube is on the
bottom.
3. Closethezipperonthebag.Make surethe
zipper is c losed completely.
4. Remove blow er tube f rom engine.
Rib
Groove
5. Inserttheelbowtube intotheblower outlet .
Make sure elbow tube r ib is aligned with
the blow er outlet gr oove.
6. Turnknobclockwisetosecure elbowtube.
VACUUM TUBE ASSEMBLY
WARNING: S top engine and be sure
the impeller blades have stopped turning be -
fore opening the vacuum inlet door or at-
tempting to insert or remove the vacuum or
blower tubes. The rotating blades can cause
serious injury.
1. Align the lower vacuum tube as shown.
Push lower vacuum tube into upper vacu-
um tube.
Lower Vacuum Tube
Upper Vacuum
Tube
2. Insert thetip of ascrewdriver intothe latch
area of the vacuum inlet.
Latch Area
Blower
Outlet
Vacuum
Inlet C over
Latch
Area
3. Gently tilt t hehandle ofthe screwdriver to-
ward the back of the unit to r ele ase t he
latch while pulling up on the vacuum inlet
cover with your other hand.
4. Hold the vacuum inletcover open untilup-
per v acuum tube is installed.
Vacuum Inlet
Vacuum
Inlet
Cover
Retaining P ost
5. Placethehooksontheupper vacuumtube
on the retaining pos ts of the unit.
6. Pivot the tube until it is secured to the
blower unit by the vacuum inlet latch.
Retaining
Post
Hook
Inlet Cover
Latch
PIVOT
HOW TO CONVERT UNIT FROM
VACUUM USE TO BLOWER USE
1. Remove the vacuum tubes by inserting
the tip of a screwdriver into the latch area
of the vacuum inlet.
2. Gently tilt handle of screwdriver toward
the b a ck of t he unit to release the latch
while pulling upon the upper vacuumtube
with your other hand.
Latch Area
3. Remove the vacuum bag.
4. Close the vacuum inlet cover and make
sure it is latched closed.
5. Reinstall the blow er tube (see BLOWER
TUBE ASSEMBLY).