Filter
Top Products
8
8. Insert a small screwdriver into aligned
holes. This will keep theshaft from turn-
ing while tightening the blade nut.
Screwdriver
9. Tighten blade nut firmly with a wrench
while holding screwdriver in position.
10. Remove the screwdriver .
11. Turn blade by hand. If the blade binds
against t he shield, or appears to be un-
even, the blade is not centered, and you
must reinstall.
NOTE:
To rem ove b la de, insert screwdr iver
into aligne d ho les. Unthread thenut andremove
parts. Be sure to store p arts a nd instructions for
future use.
OPERATION
KNOW YOUR BRUSHCUTTER ATTACHMENT
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
BRUSHCUTTERATTACHMENT.Comparetheillustrations withyourunit tofamiliarize yourself
with the location of various controls and adjustments. Save this manual for future reference.
Blade Shield
Blade
Gearbox
Shaft
Hanger
Trimmer Shield
Trimmer Head
BLADE
The BLADE is designed for cutting grass,
weeds, and brush up to 1/2 inch (1 cm) in
diameter.
TRIMMER HEAD
TheTRIMMERHEADholds cuttingline andis
designed for cutting grass and light weeds.
BLADE SHIELD
TheBLADESHIELDprovidesprotectionfrom
the spinning blade.
TRIMMER SHIELD
The TRIMMER SHIELD provides protection
from the spinning trimmer line.
OPERATING THE COUPLER
Your powerhead is equipped with a coupler
which enables optional attachments to be
installed. The optional attachments are:
MODEL:
Edger
PPB1000E.......................
Cultivator
PPB2000T...................
Blower
PPB3000B......................
W ARNING:
Always disconnect pow-
erhead spark plug before removing or instal-
ling attachments.
REMOVING BRUSHCUTTER
ATTACHMENT (OR OTHER
OPTIONAL ATTACHMENTS)
CAUTION:
When removing or installing at-
tachments, place the powerhead and attach-
ment on a flat surface for stability.
1. Loosen the coupler by turning the knob
counterclockwise.
Coupler
Knob
LOOSEN
TIGHTEN
Upper Shaft
Lower
Attachment
2. Press a nd hold the locking/release butt on.