Filter
Top Products
iiiiiiiiiiiiiiii • iiii
E. FUELING YOUR ENGINE
1. FUEl. SAFETY
a. Use only recommended fuel mixtures.
b. Mixand pour fuel outdoorsand wherethere are
no sparks or flames.
c. Use a container approved for fuel.
d. Do not smoke or allow smoking near fuet or the
tool or while using the tool.
e. Wipe upall fuel spills before starting engine.
f. Move at least 10 feet away from fueling site
before starting engine.
g. Stop engine before removing fuel cap.
h. Empty the fuel tank before storing the tool.
Use up fuel left in the carburetor by starting
the engine and letting the engine run until
_ it stops.
i. Store tool and fuel in an area where fuel
vapors cannot reach sparks or open flames
from water heaters, electric motors or swit-
ches, furnaces, etc.
2, FUEl. MIXTURE
Your tool is powered by a two-cycle engine
which requires a fuel mixture of regular unlead-
ed gasoiineand ahigh quality engine oil
specially made for 2-cycle, air cooled
engines. The internal design of the 2-cycle engine
requires lubrication of moving parts. Lubrication is
provided when the recommended mixture of
gasoline and oil is used.
• Genuine POULAN®/WEED EATER® 2-cycle
Engine Oil isstrongly recommended for the pro-
tection of your unit. Extensiveengineering tests
haveproventhatPoulan®/Weed Eate_ oilresists
break-downatoperatingtemperatures commonto
2-cycle engines, resulting in dependable perfor-
mance and longerengine life.
Gasoline must be clean and fresh. Aftera short
period oftime,gasoline willchemically break-down
and form compoundsthatcause hardstartingand
damage in2-cycleengines_
• The correct measure of gasoline to oil is very
important. Toomuch oil in the mixture willfoul the
sparkplug.
, [CAUTION: ] Too iittle oil or incorrect oil will
cause the engine to overheat and seize.
• Always mix the fuel thoroughly in a container
sincegasolineandoildonotreadilycombine.Donot
mix gasolineand oildirectlyin the fuel tank.
3. USE THE FOLLOWING ONLY:
Poulan ProTM 40:1 Engine Oil isstronglyrecommend-
ed. Available in the following convenient container
sizes, Poulan ProeM40:1Engine Oil should be mixed
as follows:
3.2 oz. Container...Mix with 1 gallon gasoline.
8 oz. Container...Mix with 2-1/2 gallons gasoline.
16 oz. Container...Mix with 5 gallons gasoline.
if Poulan Pro oil is not available use other
"Poulan/Weed Eater" branded oils at their recom-
mended mixture as listedon the container,
Ifnone oftheabove oils are available, usea good qua-
lity, two-cycle, air cooled engine oil mixed at a ratio of
16:t (8oz. oil to 1gallon gasoline),
4. DO NOT USE:
• BIA OIL (Boating Institute of America) --
--Does not have proper additives for air-cooled
2-cycleengines andcan causeengine damage.
• AUTOMOTIVE OIL --
--Does not have proper additives for 2-cycle
engines and can causedamage.
5, HOW TO MIX FUELAND FlU. TANK
a. Pour 1/2 gallon regular unleaded gasoline into an
approved, marked container.Do not mix gasoline
and oil directly in the fuel tank.
b. Addentire measure of engine oil.
c. Cover container tightly and shake for one minute.
d. Slowly remove fuel container cover.
e. Add remainder of gasoline.
f. Cover container tightly and shake again.
g. Slowly remove fuel container cover.
h. Slowly remove fuel cap. See "Specifications;'
for location.
i. Fillthe tank using a spoutor funnel.
I. Reinstall the,fuel cap securely.