One Stop Gardens 44712 Greenhouse Kit User Manual


  Open as PDF
of 16
 
Page 8 For technical questions, please call 1-800-444-3353. Item 47712
Frame Assembly
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
• Unlessnotedotherwise,attachallframepartsusingtheBolts(43)andNuts(52)provided.
Tighten nuts only about
1
/
4
turn past finger tight; be careful not to overtighten.
• Layoutallpartsbynumberpriortoassembly.
• Useanassistantoranappropriatesupport(notincluded)tokeepthepartiallyassembledpartsupright
during assembly. Use two assistants to assemble the Crown pieces to the rest of the frame.
• Assembleonaclear,calmday.WindwilldamagetheGreenhouseandmakeassemblydifficult.
Assembling the Frame Edges
(Front)
(Rear)
(Right)
(Left)
Side
Ceiling
Plate (36)
Figure G: Frame Edges
1. There are four Corner Studs (1) to be
attached to the four Floor Plates (16, 17, 34).
Attach one Corner Stud (1) on the outside of
each corner. Attach an End Cap (47) to the
top outer corner of each Corner Stud (1).
2. Once the four Corner Studs (1) are connected to the
Floor Plates (16, 17, 34), drill three pilot holes 1
1
/
2
″
through each Floor Plate and into the underlying
wood sill or base. Make sure not to drill into any of
the hardware used earlier. Then, secure the Floor
Plates to the foundation, using three 1
1
/
2
″ long wood
screws (sold separately) for each Floor Plate.
SAFETY FRAME MAINTENANCEFOUNDATION
 previous next