Filter
Top Products
Page 12 For technical questions, please call 1-800-444-3353. Item 47712
Assembling/Installing the Door
The door is assembled using the Door Screws (44).
The Screws thread directly into the rounded portions of the parts in the center of the door.
1. Place the Left Door Frame (20) with the
Rubber Seal (42) side down.
Attach the Center Door
Frames (26) to the Left
Door Frame (20).
Assemble them with the
rounded portion facing the front,
as shown to the right.
These parts are also marked
with an arrow that needs to point towards
the top of the door.
2. Attach the Right Door Frame (28) to the
Center Door Frames (26) in the same way.
3. Attach the Door Top Frame (24) to the Left and Right
Door Frames (20 and 28).
Turn them so that the rounded
portion faces the front and that
the flange where the pane will sit
faces the center of the door,
see the diagram to the right.
4. Using two Bolts (43) and two Nuts (52), attach
the Door Slider (31) to the Door Top Frame (24)
with the rollers on the top of the door.
5. Insert a Door Bottom Slider (40) into each end of the
Bottom Door Frame (27).
Install the Sliders correctly, with
the gap facing the back of the
door, see diagram to the right.
Attach the Bottom Door
Frame (27) to the Left and Right
Door Frames (20,28) using
two Screws (44) on each side –
the top one into the Bottom Door Frame (27) and
the bottom one into the Door Bottom Slider (40).
6. Raise the assembled Door up and insert the first
roller of its Door Slider (31) onto the Door Rail (14).
Carefully align the first Bottom
Door Slider (40) over the edge of
the Front Floor Plate (17),
see illustration to the right.
Carefully slide the door over and
align the other top Roller and
bottom Slider as was
done earlier.
7. Once the door is installed, install a Bolt (43)
and Nut (52) into the hole on each side of the
Door Rail (14) to prevent the door from sliding
off its rail. Attach the Right and Left Rail End
Caps (49,50) onto the ends of the Door Rail.
Assembling/Installing the Windows
Follow the steps below for each of the two windows.
1. Attach the Side Window Frames (30)
to the Top Window Frame (33),
as shown to the right.
2. Insert Bolts (43) into the
holes at the bottom of the
Side Window Frames (30), so that the threads
stick out the bottom of the window.
3. Remove the protective film from both sides
of the Window Pane (5A). Slide the Window
Pane (5A) into the three sided frame.
4. Slide the Bottom Window Frame (32) onto the two
Bolts (43) and the Window Pane (5A). Secure it in
place with Nuts (52). If needed, apply some pressure
to the heads of the Bolts through the Window
Pane to allow the Nuts to thread on properly.
5. Attach the Window Brace (51) to the Bottom
Window Frame (32) using two Window Screws (45).
The holes on the Window Brace (51)
should face away from the window.
6. Slide the top edge of the Top Window Frame (33) into
the slot at the top of the Crown (35),
see illustration to the right.
The window should be aligned with
the Window Brace (51) on the bottom.
Slide the window into place over one
Window Support Beam (15).
Gradually lower it into place.
7. Loosen the Nuts (52) holding the
Window Support Beam (15) in place and slide the
Window Support Beam (15) up to touch the window.
Secure it into place.
SAFETY FRAME MAINTENANCEFOUNDATION