Filter
Top Products
Assembly
9
Step One: Attach gauge
1. Remove and discard the plug in the gauge port.
2. Thread in pressure gauge. Hand tighten, then turn 2 full turns with a wrench.
Step Two: Attach gun hose to spray gun and pump
1. Install hose clamps on hose.
i) Slide hose clamp over the end of the hose.
ii) Push the hose onto the hose barb.
iii) Slide the hose clamp over the hose barb.
iv) Tighten the hose clamp
2. Using 2 hose clamps, attach one end of the gun hose to the pump hose barb.
3. Using 2 hose clamps, attach the other end of the gun hose to the spray gun.
Step Three: Attach gun clips to tank
Fasten one gun clip and one large gun clip to the sprayer tank with #10 x 1/4” screws.
Step Four: Attach drain cap to tank
Press the rubber washer into the drain cap with your finger and thread the drain cap onto the tank.
01976
Spray gun
Hose clamps
Gu
n h
ose
Plug
Pressure gauge
H
ose
c
l
a
m
ps
01978
Gun cli
p
#10 x ¼”
Screws
Large
gun clip
Rubber washer
Drain ca
p