Filter
Top Products
Assembly (continued)
13
8. Connect all three
power cords
together
Connect the three sprayer power cords together.
a) Check to be sure the power switch is in the “OFF” position on the remote
switch power cord.
b) Connect the one end of the remote switch power cord to the battery power
cord and the other end to the pump power cord.
9. Attach remote switch
to vehicle
Using supplied velcro pads, affix remote switch to vehicle in a position that is
easily reached from the driver’s seat.
10. Disconnect after use
AFTER EACH USE, disconnect power to the sprayer by disconnecting the
sprayer’s remote switch power cord from the battery power cord – the battery
power cord may remain connected to the battery.
NOTE: It is important to disconnect power to the sprayer when not in use,
both for safety reasons and to prevent the pump from draining the battery.
ALWAYS verify that the power has been disconnected before servicing the
sprayer.
11. To disconnect
permanently
When it is necessary to disconnect the sprayer’s battery power cord from the
battery, use the following procedure:
1. Disconnect sprayer’s remote switch power cord from the battery power cord
.
2. Disconnect the battery power cord from the vehicle battery as follows:
a) Disconnect vehicle battery ground wire.
b) Disconnect t he batt ery cord’s black battery clamp or black wire
connector from the negative(-) terminal of the vehicle battery.
c) Disconnect the battery cord’s red battery clamp or red wire
connector from the positive(+) terminal of the vehicle battery.
d) Reconnect the vehicle battery ground wire.
WARNING: Always connect in this sequence to avoid possible shock.
(Remember that on some vehicle models, you may need to remove the sprayer to
access the battery)
01981
Batter
y
p
ower cor
d
Remote switch
p
ower cor
d
P
u
m
p
powe
r
co
r
d
To Battery