Filter
Top Products
Assembly (continued)
12
Hoop
Prongs
Stri
p
½”
R
ed
w
ir
e
Handle
shield
3. Separate power
cords
Disconnect the battery power cord from the pump power cord.
4. Prepare wire ends Prepare the wire ends of the sprayer’s battery power cord for connection to
the vehicle battery:
a) Determine the type of end connectors you need to connect to your vehicle’s
battery t erminals.
b) Install battery clamps (supplied) or end connectors of your choosing on the
bare ends of the sprayer’s battery power cord wires.
To install battery clamps:
1. Remove red plastic handle
shield from red battery
clamp and slide onto red wire
2. Strip red battery cord wire ½”
3. Insert bare wire under raised hoop
on red battery clamp handle
4. Use a pliers to press hoop down and crimp wire
5. Fold prongs over wire insulation to hold wire in place
6. Push plastic handle shield back over battery clamp handle
7. Repeat for black wire and black battery clamp.
5. Connect power cord
to battery
Connect the sprayer’s battery power cord to the vehicle battery using the
following procedure:
a) Disconnect the vehicle battery ground wire.
b) Connect the remote switch’s red battery clamp or red wire connector to the
positive(+) terminal of the battery.
c) Connect the remote switch’s black battery clamp or black wire connector to
the negative(-) terminal of the battery.
d) Reconnect the vehicle battery ground wire.
WARNING: Always connect in this sequence to avoid possible shock.
6. Ve rify conne ction
Ve rify a com plete conne ction has been made by checking with a DC voltmeter,
or by briefly connecting to the pump power cord and listening for pump
activation.
7. Attach sprayer to
vehicle if haven’t yet
If you have not yet mounted the sprayer to your vehicle, do so at this time
following the instructions in “Step Six: Attach Sprayer to Vehicle”.
Batter
y
power cord
Pump power cord