Filter
Top Products
5
Reference 17 - Breather/Oil Fill Plug. Use
SAE 90 gear oil. Maintain the correct oil level.
Over filling can cause the oil to over heat and
damage seals and bearings. The gear box is
shipped with temperary plastic plug, remove and
replace with the metal breather plug that is in the
manual bag.
INTRODUCTION
Before attempting to mount your generator,
thoroughly study the instructions and cautions in this
manual to assure you are fully acquainted with the
operation of all components of this generator. Proper
preparation, operation and maintenance will result
in operator safety, best performance and long life of
the generator. NorthStar is constantly improving its
products. The specifications outlined herein are
subject to change without prior notice or obligation.
The purchaser and/or user assumes liability of any
modification and/or alterations on this equipment
from original design and manufacture. Before using,
the user shall determine the suitability of this product
for its intended use and assumes liability therein.
RULES FOR SAFE OPERATIONS
Safety precautions are essential when operating
this generator. Respectful and cautious operation
will considerably lessen the possibilities of a
personal injury. This manual will warn of specific
personal injury potential, and these will be
designated by the symbol:
WARNING This generator is equipped
with a grounding screw, located on the generator
frame for your protection. Always complete the
grounding path from the generator to a copper
pipe/rod that is driven into moist earth, to prevent
electrical shock.
ALWAYS use electrical cords that are in good
condition. Worn, bare, frayed or otherwise
damaged cords can cause electric shock.
ALWAYS use a ground fault circuit interrupter
(GFCI) in damp or highly electrical conductive
areas and on construction job sites to prevent
electric shock.
ALWAYS remove PTO driveline before working
on the generator.
ALWAYS provide adequate ventilation. Do not
operate generator in any enclosed or narrow space.
Engines consume oxygen and give off deadly
carbon monoxide, a poisonous gas. Improper
ventilation will cause damage to generator and
possible injury to people.
ALWAYS remove all oil or gasoline deposits
and accumulated dirt from generator and
immediate area. Keep generator head and engine
clean.
ALWAYS wear ear protection while operating
generator.
ALWAYS keep area around generator clean.
NEVER operate the generator without proper
guarding.
NEVER operate the generator continuously
when PTO driveline is at angle greater than 15°
both horizontally and vertically .
NEVER operate the generator while wearing
loose fitting clothing such as neckties, scarves or
untucked shirts.
NEVER operate the generator, or handle any
electrical equipment while standing in water, while
barefoot, while hands are wet or while in the rain or
snow. Electric shock may result.
NEVER operate the generator under the
following conditions:
A. Excessive change in engine speed, slow
or fast.
B. Overheating in load connecting devices.
C. Sparking or arcs from generator.
D. Loss of electrical output.
E. Damaged receptacles.
F. Engine misfire.
G. Excessive vibration.
H. Enclosed compartments, or confined areas.
I. Flame or smoke.
J. Rain, snow or wet conditions.
K. Operator non-attendance.
L. Without proper guarding in place.
WARNING Keep fire extinguisher close
by your generator and be familiar with how to use
it. Consult your local fire department for correct
extinguisher type.
DANGER Remember, exhaust fumes are
deadly carbon monoxide, a poisonous gas and
must be vented to the outside where there are no
people. Cooling air of sufficient amounts must be
brought in and exhausted out to ensure proper
cooling of the engine and generator.
INSTALLATION