Filter
Top Products
TLG-12SPX — PARTS AND OPERATION MANUAL (STD) — REV. #4 (03/08/05) — PAGE 37
2. Turn switch key to start. Once it is cranked and
starts to run, release the key (Figure 20).
3. Pull the throttle handle and turn to right until the notch
sets the handle out. (Figure 21).
1. Set the Throttle switch to “Start/Idle”(Figure 19).
Starting the Generator
4. Turn the main circuit breaker to ‘ON’ (Figure 22).
Figure 19. Throttle Handle (Idle)
Figure 20. Key switch
Figure 21. Throttle Handle (Run)
Figure 22. Main Circuit Breaker
TLG-12SPX — START UP PROCEDURE
Before Starting
Engine
1. Check the lubricating oil level prior to starting the engine.
Make sure the generator is level. The oil level must be
maintained between two notches on the dipstick.
2. When there is not enough lubricating oil, fill the
crankcase with high grade motor oil. Use a high
quality detergent oil classified CC or higher (See Table
7 on page 31).
3. Check the coolant level in the radiator and subtank.
Replenish with antifreeze as necessary. Always maintain
the coolant level between the FULL and LOW markings
on the coolant container. Be sure that the radiator cap is
fastened securely.
4. Check the fuel level on the fuel gauge. If fuel is low, fill
the fuel tank with clean fresh unleaded automotive diesel.
If diesel spillage occurs, completely wipe up the spilled
fuel immediately.
The engine's exhaust contains harmful
emissions.
ALWAYS
ventilate the
exhaust when operating inside tunnels,
excavations or buildings. Direct exhaust
away from nearby personnel.
WARNING:WARNING:
WARNING:WARNING:
WARNING: