Filter
Top Products
PAGE 34 — TLG-12SPX — PARTS AND OPERATION MANUAL (STD) — REV. #4 (03/08/05)
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION
:
TLG-12SPX — PRE-SETUP
Day-to-day addition of coolant is done from the reserve tank.
When adding coolant to the radiator, . See Table 8 for engine,
radiator, and reserve tank coolant capacities. Make sure
the coolant level in the reserve tank is always between the
"H" and the "L" markings.
Cleaning the Radiator
The engine may overheat if the radiator fins become
overloaded with dust or debris. Periodically clean the radiator
fins with compressed air. Cleaning inside the machine is
dangerous, so clean only with the engine turned off and the
battery disconnected.
Air Cleaner
Periodic cleaning/replacement is necessary. Inspect it in
accordance with the Isuzu Engine Owner's Manual.
Fan Belt Tension
A slack fan belt may contribute to overheating, or to
insufficient charging of the battery. Inspect the fan belt for
damage and wear and adjust it in accordance with the Isuzu
Engine Owner's Manual.
The fan belt tension is proper if the fan belt bends 7 to 10
mm (Figure 15) when depressed with the thumb as shown
below.
Never place hands near the belts or fan while
the generator set is running.
CAUTION :CAUTION :
CAUTION :CAUTION :
CAUTION :
When adding coolant or antifreeze to the
radiator, do not remove the radiator cap
until the unit has completely cooled.
Operation in Freezing Weather
When operating in freezing weather, be certain the proper
amount of antifreeze (Table 9) has been added.
serutarepmeTgnitarepOezeerF-itnA.9elbaT
%loV
ezeerF-itnA
tnioPgnizeerFtnioPgnilioB
C°F°C°F°
0442-21-601222
0573-43-8016
22
When the antifreeze is mixed with
water, the antifreeze mixing ratio must
be less than 50%.
NOTE
yticapaCtnalooC.8elbaT
rotaidaRdnaenignE)L5.3(.laG29.0
knaTevreseR)L1(.laG62.0
Figure 15. Fan Belt Tension