Filter
Top Products
PAGE 26 — SP 1 SAW CE— OPERATION AND PARTS MANUAL — REV. #3 (06/09/08)
MQ STREET PRO 1 CE SAW — OPERATION
Restarting After Intervention
If cutting is interrupted where the engine stops or is turned off
while the blade is still in the cut:
a. Turn Engine Off switches to "OFF"
b. Raise the blade out of the cut
c. Restart the engine as described in the previous
section.
If cutting is interrupted where the blade is stuck in the cut:
a. Turn Engine Off switches to "OFF".
b. Remove the blade guard.
c. Remove blade mounting bolt and outer flange.
d. Maneuver the saw away from the stuck blade.
e. A parallel cut made next to the blade may be necessary
to free it.
f. Once the blade is freed inspect the blade for damage;
discard if damaged.
e Ensure an undamaged, useable blade is installed on
the saw before cutting is resumed with that saw.
The only acceptable method for freeing a stuck blade is to
remove the saw from the stuck or pinched blade. DO NOT
try to get the blade unstuck using the Raise/Lower system
or by lifting the saw by the lifting bale, etc.
CAUTION