Filter
Top Products
LT12DAB LIGHT TOWER • OPERATION MANUAL — REV. #0 (06/03/11) — PAGE 5
SAFETY INFORMATION
LIGHT TOWER SAFETY
DANGER
NEVER use light tower in rain, snow, or
areas of high humidity that could generate
electrical storms.
NEVER operate the equipment in an explosive
atmosphere or near combustible materials. An
explosion or fi re could result causing severe
bodily harm or even death.
WARNING
NEVER disconnect any emergency or safety devices.
These devices are intended for operator safety.
Disconnection of these devices can cause severe injury,
bodily harm or even death. Disconnection of any of these
devices will void all warranties.
CAUTION
NEVER lubricate components or attempt service on a
running machine.
ALWAYS ensure light tower is on level ground before use
so that it cannot slide or shift around, endangering workers.
Always keep immediate area free of bystanders.
ALWAYS make sure trailer is leveled with all outriggers
extended before raising tower. Outriggers must remain
extended while tower is up.
ALWAYS keep area behind trailer clear of people while
raising and lowering mast.
NEVER remove safety pin or pull mast locking pin while
tower is in a raised position!
CHECK the mast and winch cables for wear. If any
problem occurs when lowering or raising the tower,
STOP immediately! Contact a trained technician for
assistance.
NEVER pivot or retract mast while unit is operating.
NEVER use the light tower mast as a crane. DO NOT lift
anything with the mast.
NEVER attach anything to the light tower mast.
ALWAYS lower the light tower when not in use, or if high
winds or electrical storms are expected.
NOTICE
ALWAYS
keep the immediate area surrounding the light
tower clean, neat, and free of debris.
ALWAYS
keep the machine in proper running condition.
Fix damage to machine and replace any broken parts
immediately.
ALWAYS
store equipment properly when it is not being
used. Equipment should be stored in a clean, dry location
out of the reach of children and unauthorized personnel.
To prevent the light tower from overturning, NEVER
use
in winds that exceed 65 mph (105 kph).
LAMP SAFETY
WARNING
NEVER attempt to replace lamp with the power on.
Always shut down the engine and turn off circuit breakers
when changing the lamp.
ALWAYS
allow a suffi cient amount of time for the lamp to
cool
before touching or changing. The possibility exists of
severe burns.
CAUTION
NEVER
use force when installing the lamp. Excessive force
could cause the lamp to break, causing bodily harm.
NOTICE
NEVER
leave any grease or oil residue on lamp surface
when replacing or removing lamp. This can create hot
spots, reducing the service life of the lamp.
ALWAYS make sure lamp surface is clean and dry.
ALWAYS replace with MQ recommended type lamp.
ALWAYS have a trained technician
install and remove
a fl oodlight, or replace any damaged fi xture wiring.