Filter
Top Products
LT12DAB LIGHT TOWER • OPERATION MANUAL — REV. #0 (06/03/11) — PAGE 17
COMPONENTS
14. Safety Chain — Always attach safety chain to the
towing vehicle. Never tow the light tower with the safety
chain unattached.
15. Ball Hitch Coupler — Attach this coupler to the
towing vehicle. Use only the specified ball diameter
as indicated on your coupler. Use of any other ball
diameter will create an extremely dangerous condition
which can result in separation of the coupler and ball
or ball failure.
16. Vertical Mast Winch — Use this winch to raise the
mast to the vertical position.
17. Mast Lock/Release Pin — Pull this pin to start placing
the tower mast in the vertical position.When tower mast
has reached full vertical position, insert pin to keep
mast from falling.
18. Tie-Down Points — Used to tie down light tower with
strap or chains to allow even application of force to the
front and rear of the equipment during transport.
19. Engine Exhaust Pipe — Directs engine exhaust to
the rear of the light tower. NEVER block this exhaust
pipe with obstructions. ALWAYS place the generator
in an area free of obstructions.
20. Tires — This light tower uses a ST175-13C size tire.
Replace with only recommended tire size. Never tow
light tower with bad or worn tires.
21. Documentation Box — Contains information
regarding the light tower.
22. Auxiliary Output Receptacle — Wired ready to install
an output receptacle.
23. Auxiliary Output Receptacle — Wired ready to install
an output receptacle.
Figure 4. Major Components (Front/Rear)
REAR
VIEW
20
21
23
22
FRONT
VIEW
19