Multiquip LT12DAB Landscape Lighting User Manual


 
LT12DAB LIGHT TOWER • OPERATION MANUAL — REV. #0 (06/03/11) — PAGE 21
1. To check the engine fuel level, make sure the light
tower is placed on secure level ground with the engine
stopped.
2. Lift the light tower access door (Figure 7) opposite the
control panel. Set the door support latch in place to
keep the door open (up).
Figure 7. Adding Fuel
3. Remove the fuel cap from the fuel tank.
4. Pay attention to the fuel tank capacity when replenishing
fuel. The fuel tank cap must be closed tightly after filling.
Handle fuel in a safe container. If the container does
not have a spout, use a funnel.
5. Wipe up any spilled fuel immediately!
BATTERY CHECK
CAUTION
ALWAYS fill the fuel tank with clean, fresh #2 diesel
fuel. DO NOT fill the fuel tank beyond its capacity. DO
NOT TOP-OFF.
WARNING
The operator must wear the appropriate
protective equipment and clothing while
handling the battery.
Failure to wear protective equipment or clothing could
result in serious injury.
INSPECTION
The 12-volt DC battery (Figure 8) is shipped dry and will
require a proper electrolyte level for operation.
Figure 8. Battery
When servicing of the battery is required, perform the
following:
A face shield and rubber gloves should be worn while
handling and servicing the battery's electrolyte.
Disconnect battery terminal clamps, and remove the
battery from the generator cabinet when servicing is
required.
DO NOT overfill the battery.
WARNING
Electrolyte is an acid and must be
handled with caution. ALWAYS follow
servicing instructions from the electrolyte
manufacturer to ensure safety. Serious
injury can result from careless handling and
noncompliance to safety handling instructions.
Overfilling the battery may cause the electrolyte to
overflow resulting in corrosion to nearby components.
Immediately wash off any spilled electrolyte (battery
acid).
WARNING
When connecting the positive (+) cable
to the battery's positive (+) terminal post,
DO NOT allow the wrench or any metallic
part to come in contact with the battery's
negative (-) terminal post. This may result in an electrical
short circuit or an explosion. Always connect positive
(+) end first then negative (-) end. Always disconnect
(-) end first then positve (+) end.
NOTICE
Use only distilled water in the battery. Tap water can
reduce the operating life of the battery.