Filter
Top Products
PAGE 38 — GLOBUG LIGHTING SYSTEM • OPERATION AND PARTS MANUAL — REV. #0 (07/23/09)
NAMEPLATES AND DECALS (GBS)
A-0000000-00
To avoid accident or injury exceed a travel speed of 6 MPH when using lighting system on mobile equipment.NEVER
Make sure the power cable from the generator is connected to the lamp power cable securely.A loose connection may cause
a short circuit.
NEVER operate any of the GloBug lighting systems or handle any electrical equipment while standing in water, while barefoot,
while hands are wet, or in the rain. Adangerous could occur causingelectrical shock Severe Bodily Harm or even Death !
NEVER disconnect the connector when power is applied. The possibility exists of or equipment damege.Electricalshock
Once lamp is turned ,Allow lamp to cool down before turning backOFF
on. It will take about 5 minutes before lamp can be turned back on.
ALWAYS disconnect theAC power cable from generator first, before
shutting down generator.
ALWAYS turn on generator first,before connecting theAC power
cable to the generator.
To prevent burns, touchNEVER
lamp while lamp is on. Lamp
surface gets extremely hot!
ALWAYS allow sufficient time
for lamp to beforecool down
touching.
To avoid injury, you readMUST
and understand operator's manual
before using this machine.
To avoid accident or injury make certain hardware is securely fastened on pipe clamps.ALWAYS
To prevent the lighting system from breaking, use in strongNEVER
winds that makes balloon deformed considerably.
ALWAYS OFFturn generator before performing maintenance.
To prevent breaking, use in strong winds that makes balloon deformed considerably.NEVER
TM
GloBug Lighting System
Lamp OFF
switch
Push the button in the hole with a small
flat-blade screwdriver (or similar tool) for
3 seconds. LED will turn green.
5
1
2
3
4
6
MODEL
SERIALNO.