Multiquip GBW Landscape Lighting User Manual


 
PAGE 26 — GLOBUG LIGHTING SYSTEM • OPERATION AND PARTS MANUAL — REV. #0 (07/23/09)
MAINTENANCE
REPLACING LAMP
\
Unzip the zipper at the bottom of the balloon and roll 1.
the balloon up to expose the lamp. See Figure 35.
Exposing BalloonFigure 35.
Release the lamp guard locking tabs. See Figure 36.2.
Removing Lamp GuardFigure 36.
DANGER
Never attempt to replace lamp in a wet place. The
possibility exists of electric shock.
WARNING
Always allow suffi cient time for the lamp to
cool down before replacing. The possibility
exists of severe burns if hot lamp is
touched.
CAUTION
Always shutdown power source and remove balloon
assembly from mast when replacing a broken lamp.
Utmost care should be taken in handling broken lamp.
The possibility exists of serious injury from handling a
broken lamp.
BALLOON
ZIPPER
LOCK TAB
LAMP GUARD
Remove the lamp guard.3.
Press the tabs on the lamp holder and push up lamp 4.
holder to release it from lamp. See Figure 37.
Lamp HolderFigure 37.
Remove the lamp from the lamp socket by turning lamp 5.
counterclockwise. See Figure 38.
Removing LampFigure 38.
Install new lamp into socket and turn lamp in a 6.
clockwise direction until tight. See Figure 39.
Installing New LampFigure 39.
LAMP HOLDER
LAMP
HOLDER
STOPPER
LAMP
LAMP
SOCKET
LAMP
LAMP
SOCKET