Multiquip GBW Landscape Lighting User Manual


 
GLOBUG LIGHTING SYSTEM • OPERATION AND PARTS MANUAL — REV. #0 (07/23/09) — PAGE 25
STORAGE (GBW/GBWE)
Before storing the GBW/GBWE Lighting System, perform
the following steps.
Disconnect the lamp connector from the AC power 1.
cable.
Unhook the AC power cable from the eyelet at the 2.
bottom of the balloon.
Make sure the mast is completely lowered as described 3.
in LOWERING THE MAST section.
Lock the buckle to secure the balloon together.4.
Unzip the zipper on the protective cover and pull down 5.
cover over the balloon/lamp assembly.
Place the AC power cable in the pocket inside the 6.
protective cover and attach velcro tabs.
Loosen the T-bolt on the balloon/lamp assembly and 7.
lift balloon/lamp assembly from the mast.
Lift mast while pulling up strap (Figure 31).8.
Unlocking the LatchFigure 31.
NOTICE
Allow about 15 to 20 minutes for the lamp to cool down
before storing the GBW/GBWE. The possibility exists of
the balloon getting burned if it touches a hot lamp.
UPPER
POSITION
LATCH
LOWER
POSITION
OPERATION
Continue pulling upward on the mast until all the 9.
pentapod legs are fully retracted and are stowed. See
Figure 32.
Stowing the PentapodFigure 32.
Once pentapod legs are all in stow position, wrap strap 10.
around all fi ve legs and secure by locking the buckle.
See Figure 33.
Locking Up Stowed PentapodFigure 33.
Place the stowed pentapod inside the carrying case. 11.
See Figure 34.
Storing in Carrying CaseFigure 34.
STRAP
PENTAPOD
STOWED
BUCKLE
STRAP
STOWED
PENTAPOD
CARRYING
CASE