Filter
Top Products
PAGE 20 — GLOBUG LIGHTING SYSTEM • OPERATION AND PARTS MANUAL — REV. #0 (07/23/09)
SETUP
BALLOON INSTALLATION (GBW/GBWE/GBS)
Insert the balloon assembly into the mast. Tighten the 1.
T-bolt securely. See Figure 15.
Installing the BalloonFigure 15.
Unsnap the three buttons on the bottom of the balloon 2.
cover and unzip the cover. See Figure 16
Remove the AC Power Cable from the inside pocket 3.
of the balloon cover. See Figure 16.
Removal of AC Power Cable from Figure 16.
Balloon Cover
Fold the balloon cover into itself and zip it up. See 4.
Figure 17.
Folding Balloon CoverFigure 17.
T-BOLT
MAST
BALLOON
PROTECTIVE
COVER
ZIPPER
BUTTON
AC POWER
CABLE
FOLD PROTECTIVE
COVER INTO ITSELF
BALLOON
FULLY
EXPOSED
ZIPPER
Connect the power cable to the lamp cable connector. 5.
See Figure 18.
Connecting the Power CableFigure 18.
Secure the power cable by hooking it to the eyelet on 6.
the bottom of the balloon as shown in Figure 19.
Securing Cable with HookFigure 19.
Release the buckle on the belt holding the balloon 7.
together. See Figure 20.
Releasing BuckleFigure 20.
LAMP CABLE
CONNECTOR
POWER CABLE
CONNECTOR
CABLE HOOK
BUCKLE